Nowadays, more and more families choose to install plumbing and geothermal floors during decoration. However, due to higher maintenance requirements for plumbing and geothermal floors, consumers must pay more attention to details when paving and using them, especially when central heating is about to begin. During the week, we must pay special attention to debugging geothermal floors at home.
Heating should be gradual for the first time
When using geothermal heating for the first time, attention should be paid to slowly heating up. When using it for the first time, the temperature will gradually increase in the first three days of heating: the water temperature will be 18 ° C on the first day, 25 ° C on the second day, and 30 ° C on the third day. It will only rise to the normal temperature on the fourth day, that is, the water temperature will be 45 ° C, and the surface temperature will be 28 ° C ~30 ° C. Don't heat up too fast. If you do it too fast, the floor may crack and twist due to expansion. When the geothermal heating system is used again after a long time, the temperature must be strictly followed by the heating program just like the first time it was used.
Avoid dryness and monitor indoor humidity carefully
The climate is dry in winter and the use of geothermal heating makes the floor easy to dry when exposed to high temperatures for a long time
Crack, at this time, it is necessary for the owner to humidify the room to avoid cracking and deformation of the floor. During decoration, be careful not to punch holes or nail in the ground, so as not to leak the geothermal pipeline, causing water to run out of the geothermal system and the floor to be scrapped when soaked in water. Since the surface temperature of the floor is relatively high, it is best not to place glassware and porcelain holding water directly on the ground in the room to avoid uneven heating, causing "water to overflow" in the home.
The ground temperature should not be too high during use
It should be noted that when using geothermal heating, the surface temperature should not exceed 28 ° C, and the water pipe temperature should not exceed
45 ° C. If this temperature is exceeded, it will affect the service life and service cycle of the floor. Ordinary home
Ting, when the room temperature reaches around 22℃ in winter, it is already very comfortable. If the temperature rises normally, it will not affect the use of geothermal floors.
